comicsarah55

Patio Doors Repairs Patio doors give homeowners sunlight and fresh, air. They also enhance the value of homes. In time, however they can develop issues that require immediate attention. Understanding how patio doors operate will help homeowners communicate better with contractors about issues they face. Here are some of the most frequently encountered problems with patio doors: Rollers that aren't aligned properly It's not always easy to open a patio sliding door. Most of these non-cooperative sliding patio doors can be fixed by a little oiling and cleaning, unless a structural problem is present. The most frequent cause is dirt in the lower track, which could cause the rollers to be pushed against the track below and cause them to be misaligned. In this case clean the track thoroughly and apply a thin layer of lubricant to allow the rollers to glide easily. Misalignment may also be caused by damage or wear to the hinges that connect the doors that house a portion of these rollers, springs (whether extensions or torsion) as well as cables that lift the door. When worn or damaged, these components can affect the alignment of the rollers, leading to resistance and other problems such as a heavier door or higher energy costs. Regular maintenance checks and periodic professional inspections can ensure that all the components are in sync to ensure that your patio door is operating smoothly. To determine the alignment of rollers and alignment, place a crow's foot at one end of the track. use a tramming stick to sweep across both rollers, recording the distance each travels. Repeat the process at the other end of the track and divide by two to find the alignment of the rollers (Photo 1). This method isn't as precise as using a pi tape to measure the length directly. It is however, faster and easier than using a carpenter's or level to measure the length of each rail. Another option to check the alignment of the rollers is to remove the head stop, a flat plate that is located on the door jamb at the bottom of the frame that blocks the rollers. If the door is heavy you may require help in removal of the removable grilles and shades. After the head stop has been removed, remove the screws that adjust the head track by backing them out with an screwdriver. Reinstall the assembly by aligning each screw adjustment for the roller with the access hole for it and tapping it in using a Hammer. Tracks that are damaged or dirty Sliding patio door can act as a magnet for dirt, debris and other elements. They also are susceptible to misalignment, as well as other issues that require professional repair. To extend the life of your patio doors, it's essential to find and fix these issues as soon as possible. Dirty tracks are one of the most frequent causes of problems with sliding patio doors. Over time dirt and other debris such as food crumbs, pet hair and yard debris, could get trapped in the narrow spaces between your sliding door tracks, causing it to get stuck or difficult to open. To avoid problems like this it is recommended to clean and vacuum your patio door tracks at least once per month. You can clean your patio door tracks with a non-abrasive cleaner or with warm soapy tap water after having removed any loose debris. If you notice that certain areas of the track are difficult to clean, use a butter knife or toothbrush to scrub these tiny areas. It is also recommended to lubricate the tracks frequently to prevent your sliding door becoming stuck or difficult to open. If you have Panda patio doors, we suggest applying silicone spray to your bottom track on a regular basis. You can also rub paraffin wax along the track to improve glide. Another common issue that can impact your sliding patio door is draft or air leak. This may occur when the weather stripping on your sliding patio door has damaged or worn out. This can result in a gap between the frame and the door that allows air to enter and reduce energy efficiency. Make sure that your weatherstripping is in good condition and replace it if necessary. Over time your patio door could experience normal wear. These problems are usually not indicative of a major problem. Minor repairs can extend the lifespan of your patio door. Call a professional as quickly when you notice any issues to avoid future costly repairs. patio door repair Repair My Windows And Doors that is cracked or warped A patio door that is cracked or warped can be a real eyesore and could be a security risk. It also allows in unwanted animals and cause your home's temperature fluctuate dramatically. Thankfully, these problems are usually fixable when they are caught early. First, a quick glance at the glass can help determine what type of repair is required. Glass cracks are typically caused by stress or impact. They are more difficult to fix than simple chipping on the surface. A professional may require re-leading the panel. This will require removing the glass, cleaning it, and replacing broken pieces. To make sure that the new glass to the old, professionals require exact documentation of how the piece looked at the time. Plastic epoxy can be used to fill a crack. You can purchase this at a hardware store or in the home improvement section. A professional will usually use the soldering iron to melt the plastic, then apply it to the crack in the glass. After the plastic has cooled down it is then removed by the professional any excess. If the crack isn't too large it is possible to repair the glass by using clear sealant. This type of product is available at any hardware store. It is crucial to dry the crack thoroughly before applying sealant. This will stop the repair from failing. You can speed up the process by using a hair dryer or another fan. Weatherstripping damaged A damaged weather stripping is not just ugly and a security risk but it also allows outside air to enter and cold or hot air escape. A simple fix using a new piece of weather stripping can save you money while keeping your home more comfortable. Make sure you have the appropriate tools and materials. You will need an additional weather-stripping kit, or adhesive/caulk sealing agent (depending on the repair method you decide to use), pliers and scissors, a utility knife, protective goggles or gloves and a replacement weather-stripping kit. Remove the old weather stripping by cutting through one end piece, then pulling it up, along with any screws that attach it, when applicable. Remove any remaining pieces with pliers and a plier. If you decide to replace the weather stripping, begin by measuring the gap around your door frame. Use the measurements to determine what size weather stripping you will need. Make sure you leave extra length to allow for fine-tuning later. Once you have the correct size then apply the backing of the adhesive and press it against the frame. If you wish, nail it to the frame using small nails or hammers. Finally apply some wood filler to any holes or divots in the frame. Allow the filler to dry completely before applying paint. It is best to use oil-based paints but latex will also work. Last but not least, clean your sliding door tracks and doors frequently. This will help prevent future issues such as sticking. Maintaining regular maintenance and repairs to your patio doors ensures they are practical, attractive and energy efficient. You'll save money while enjoying the great outdoors while doing it. Enjoy your home improvement projects!